Sper-scientific 840099 Datalogging Manometer Manual do Utilizador

Datalogging Manometer 840086, 840098 and 840099 Instruction Manual

10 5. By default, the first reading will be stored in memory location 01: using the date & time as the filename. The pressure reading is displ

11 Clear All Memory Records 1. Press F2 (MEM) to enter Multiple Measurement mode. 2. Press F4 (NEXT) then press F2 (CLR) for two (2) se-conds. Afte

12 MEASUREMENT PROCEDURES Run Auto Logger 0023: 06-30. 02:28:55 P: 0.1 psi 0024: P: 0025: P: P-PG N-PG

13 MEASUREMENT PROCEDURES 4. Press F4 (ENTER) after modifying a parameter. 5. Once the parameters have been set press F4 (NEXT) and F1 (START) to s

14 AUTO POWER OFF To prolong battery life, the meter will turn off automatically if no buttons are pressed for your preset (1~20 minutes). To edit or

15 BATTERY REPLACEMENT When the low battery icon is displayed, open the battery cover, install 4-AAA Alkaline batteries and replace the cov-er. Remo

16 Unit of Measure Range Resolution PSI ±2 0.001 inH2O ±55.36 0.01 kPa ±13.79 0.01 ftH2O ±4.614 0.01 inHg ±4.072 0.01 cmH2O ±140.6

17 SOFTWARE CONFIGURATION Use the included USB 2.0-P cable and software to down-load saved data to a PC for further analysis, or to upload pre-edi

18 SOFTWARE CONFIGURATION Figure 2. Com Port 1. Select the Com port and ensure that the meter is com-municating with the PC. 2. The selected Com

19 SOFTWARE CONFIGURATION Figure 3. Print Options Select the data to be printed from the following three (3) choices: (see Figure 4) 1. All Data (

TABLE OF CONTENTS Introduction ………………………….. 3 Front Panel Descriptions ………………………….. 4 Measurement Procedures ………………………….. 8-14 Error Codes ……………………

Sper Scientific warrants this product against defects in materials and workmanship for a period of ONE (1) year from the date of purchase, and agrees

3 INTRODUCTION This Manometer is ideal for measuring gauge pressure and low differential pressure in clean rooms, test and balance, medical equipme

4 FRONT PANEL DESCRIPTION Connectors Display On Screen prompts correspond to the F1-F4 buttons. Keypad, press: 1 for 1*:$+-=, 2 for 2abc

5 SET-UP PROCEDURE LCD Cont. (1-5): 3 Prn Cont. (1-9): 5 Auto Off: 20mins Enable EXIT EDIT NEXT

6 SET-UP PROCEDURE 1.LCD Cont. (1-5): Display con-trast, 5 = least contrast. 2.Auto Off: 1~20 minutes, Enable/Disable. 3.Set Clock: Select the dat

7 Calibration 1. Full (HI-LOW) calibration requires a standard manome-ter calibrator and should be performed by a professional calibration laborato

8 MEASUREMENT PROCEDURES Measurement Modes The unit offers three (3) measurement modes: 1. F1 (MEAS) Single Measurement 2. F2 (MEM) Multiple Mea

9 MEASUREMENT PROCEDURES Multiple Measurement Manually record up to 99 data points with time & date and your filename. 1. Press F2 (MEM) to ent